LPF

LPF （Low Pass Filter） は、設定したカットオフ周波数よりも低域だけを通して高域をカットするフィルターです

CUTOFF周波数より高い周波数の音を削ることで音がこもったような質感になったり、CUTOFFを小さい値から大きな値に変化させることで開放感を演出できます

LPF (Low Pass Filter) is a filter that allows only the frequencies below the specified cutoff point to pass while attenuating the higher frequencies.

By reducing the frequencies above the cutoff, the sound acquires a muffled quality. Conversely, gradually increasing the cutoff value from a lower to a higher setting can create a sense of openness and expansion.

Parameter

① RATE: フィルターのカットオフ周波数を変化させる周期（スピード）を設定

② DEPTH: カットオフ変化の振れ幅を設定

③ RESONANCE: カットオフ周波数付近の音を強調する度合いを設定

④ CUTOFF: フィルターが高音をカットし始める周波数を設定

⑤ STEP RATE: カットオフ変化を階段状に分割する設定

① RATE: Sets the cycle (speed) at which the filter’s cutoff frequency changes.

② DEPTH: Sets the range of variation in the cutoff frequency.

③ RESONANCE: Adjusts the degree of emphasis on the frequencies near the cutoff point.

④ CUTOFF: Specifies the frequency at which the filter begins to attenuate the higher frequencies.

⑤ STEP RATE: Divides the cutoff frequency changes into stepped segments.

Category

EQ
Modulation

Demo

Effect Chains

    1. OSC BOT
      OSC: SAW
      TONE: -50
      NOTE: E2

    2. LPF
      CUTOFF: 12

    3. SYNTH
      FREQUENCY: 100
      RESONANCE: 0
      DECAY: 100
      BALANCE: 100

    4. PREAMP
      AMP TYPE: NATURAL CLEAN
      SPEAKER TYPE: OFF

    トラックのTEMPO SYNC MODEをPITCHにして0.5倍速にすると1オクターブ下がり、これにTRANSPOSEをかけるとベースラインを作ることができる

    By setting the track’s TEMPO SYNC MODE to PITCH and slowing it down to 0.5x speed, it drops one octave. Applying TRANSPOSE to this lets you create a bassline.

    • LPF
      RATE: 0
      DEPTH: 98
      RESONANCE: 98
      CUTOFF: 21

    • DIST
      TYPE: DS
      TONE: 0
      DIST: 30

    • OCTAVE
      OCTAVE: -1 OCT
      MODE: 2
      OCTAVE LEVEL: 100

    • EQ

    舌を弾くような音（Beatboxのコンガの音）にエフェクトをかけて作っています

    It’s created by applying effects to the tongue-flicking sound of the “te” articulation (the Beatbox Dry Kick)

    1. OSC BOT
      OSC: SAW
      TONE: -50
      NOTE: E2

    2. LPF
      CUTOFF: 12

    3. LO-FI
      BIT DEPTH: 4
      SAMPLE RATE: OFF
      BALANCE: 100

    トラックのTEMPO SYNC MODEをPITCHにして2倍速にすると1オクターブ上がり、これにTRANSPOSEやPITCH BENDをかけてメロディーを作る

    By setting the Track’s Tempo Sync Mode to Pitch, doubling the speed raises the sound by one octave. Combining this with Transpose or Pitch Bend allows you to craft melodic phrases.

    1. OSC BOT
      OSC: SAW
      TONE: -50
      NOTE: E2

    2. LPF
      CUTOFF: 12

    3. SYNTH
      FREQUENCY: 100
      RESONANCE: 0
      DECAY: 100
      BALANCE: 100

    4. PREAMP
      AMP TYPE: NATURAL CLEAN
      SPEAKER TYPE: OFF

    トラックのTEMPO SYNC MODEをPITCHにして2倍速にすると1オクターブ上がり、これにTRANSPOSEやPITCH BENDをかけてメロディーを作る

    By setting the Track’s Tempo Sync Mode to Pitch, doubling the speed raises the sound by one octave. Combining this with Transpose or Pitch Bend allows you to craft melodic phrases.

SQUARE Wave